2018 Chrysler 300 Air Filter in Danvers, MA

The engine air filter sits inside the air box in the engine bay, typically on the driver’s side of the 2018 Chrysler 300.

This enclosure feeds the 3.6L V6 intake, shielding the mass airflow path from dust and debris common on New England roads. Access usually involves releasing clips or fasteners on the air box lid and lifting the old element straight out. If you prefer professional installation in Danvers, our team can inspect the intake ducting and sealing surfaces during the swap.

• Air box in engine bay; driver’s side on most 2018 Chrysler 300 models
• Protects the V6 intake path and sensors
• Quick visual check for debris and proper air box sealing

The cabin air filter is located behind the glove box on the 2018 Chrysler 300.

This position lets the filter clean HVAC airflow before it reaches passengers, capturing pollen and fine road dust common around Danvers and the North Shore. Access may require lowering the glove box and removing a small access panel. If trim removal isn’t your preference, schedule an appointment and we’ll replace it cleanly and dispose of the old element properly.

• Behind the glove box, at the HVAC intake
• Filters pollen, dust, and odors before cabin airflow
• May require minor trim/panel removal for access

The engine air filter protects the 3.6L V6’s intake air, while the cabin air filter cleans HVAC air for passengers in the 2018 Chrysler 300.

Under-hood filtration helps maintain smooth combustion and sensor accuracy; the interior filter improves breathing comfort and reduces odors. Both matter for New England driving—road grit affects the engine filter, and regional pollen impacts the cabin filter. Using Mopar-spec elements preserves fitment and effectiveness.

• Engine: safeguards intake tract and airflow sensors
• Cabin: reduces allergens, dust, and odors in the cabin
• Mopar-spec filters ensure proper seal and flow

Five key signs include reduced power, lower fuel economy, rough idle, weak HVAC airflow, and musty cabin odors.

On the 3.6L V6, a restricted engine filter can dull throttle response and skew airflow readings. Inside, a dirty cabin filter can limit defrost performance and circulate stale air—noticeable during high-pollen seasons around Danvers. If you observe these symptoms, a quick inspection can confirm loading or contamination.

• Engine: sluggish acceleration and decreased MPG
• Engine: uneven idle, intake noise changes
• Cabin: reduced vent flow, dusty smell from vents

Yes—engine filters are generally DIY-friendly on a 2018 Chrysler 300, while cabin filters often benefit from dealer installation.

The engine air box uses simple clips or screws, but the cabin filter sits behind the glove box and can involve delicate trim. Our Danvers service team adds value with an intake housing check, a visual MAF inspection, and proper disposal. If you prefer professional help, you can schedule service online.

• DIY: engine filter access via air box lid
• Dealer: clean cabin filter swap without trim damage
• Includes intake seal check and MAF visual

Yes—our Danvers service center installs Mopar OEM air filters on the 2018 Chrysler 300.

Mopar elements meet Chrysler’s specifications for filtration efficiency, airflow, and fit, helping protect the V6 engine and your HVAC system. OEM fitment also supports proper sealing and consistent performance in New England’s varied climate. Ask our advisors about current service specials before you book.

• Mopar OEM: designed for Chrysler applications
• Correct dimensions for air box and cabin housing
• Supports sustained performance and longevity

Book online using our schedule service tool for the 2018 Chrysler 300 in Danvers.

Choose a convenient time at our modern facility at 107 Andover St (Route 114), then arrive via Route 114 with easy access from Peabody, Beverly, Lynnfield, Andover, and Salem. You can also review current service specials before confirming your appointment.

• Online scheduling available 24/7
• Convenient North Shore access via Route 114
• Check specials before you book

Yes—coastal pollen, road sand, and seasonal debris around the North Shore can load engine and cabin filters faster.

Frequent trips through construction zones, salted winter roads, or high-pollen spring corridors around Danvers, Peabody, and Salem can accelerate filter contamination. If you notice airflow changes or odors, plan a check sooner. Our team can inspect both filters during a single visit.

• Coastal pollen and leaf debris increase cabin filter load
• Road grit and salt affect engine intake filtration
• Consider earlier inspections after dusty or winter driving

Yes—the intake housing and mass airflow (MAF) area should be visually inspected during filter replacement.

On the 3.6L V6, debris or gaps at the air box seal can bypass the filter and affect sensor readings. A quick visual of the MAF area and ducts helps ensure consistent drivability and fuel economy. Our Danvers team performs this check with each filter service.

• Inspect air box seals and ducts for cracks or gaps
• Confirm clean MAF area and secure connections
• Replace filter with Mopar-spec element for proper seal

Our process starts with a guided inspection of both filters on your 2018 Chrysler 300, followed by a clean replacement if loading or contamination is found. For the engine, we open the air box, assess the element and sealing surfaces, and check the intake ducting for cracks or loose fittings. We then perform a visual review of the mass airflow area to confirm no debris or oil residue is present. For the cabin, we access the panel behind the glove box, remove dust and leaves from the housing, and install a Mopar-spec filter for correct fit and airflow. We finish with proper disposal of old elements and a quick HVAC function check. Ready to book? Use our online tool to schedule service today.

The 2018 Chrysler 300 uses two filters: an engine air filter that protects the 3.6L V6 intake and a cabin air filter that cleans HVAC airflow. Mopar OEM filters are engineered for Chrysler applications, ensuring the correct dimensions, sealing surfaces, and flow characteristics the engine management system expects. While the engine filter guards combustion air and airflow sensors, the cabin element targets pollen, dust, and odors to keep the interior fresh—especially useful during North Shore pollen peaks. Correct fitment prevents unmetered air leaks that can affect drivability. If your driving routine includes salted winter roads or dusty summer construction, inspect more often for debris loading. Bring your 2018 Chrysler 300 to Herb Chambers Chrysler Dodge Jeep RAM FIAT of Danvers in Danvers for OEM-spec filter service — schedule service.

Located at 107 Andover St (Route 114), our Danvers service center supports North Shore and Greater Boston drivers from Peabody, Beverly, Lynnfield, Andover, and Salem. Regional driving introduces coastal pollen, winter salt, and construction dust that can load both engine and cabin filters more quickly. We install Mopar OEM filters to maintain the 2018 Chrysler 300’s performance and in-cabin air quality through changing New England seasons. Appointments are easy to book online, and you can review current offers before you come in. For directions or to plan your visit, start with our online tools, then head to Route 114 for convenient access and on-site assistance.