2016 RAM 2500 Air Filter in Danvers, MA

The engine air filter sits in the engine bay inside a rectangular airbox connected to the intake tube on the passenger side.

This location allows quick access for inspections on the 5.7L V8. Pop the hood, locate the intake tube, and follow it to the airbox with metal clips or screws. Keeping this filter clean helps the 383-hp engine maintain smooth airflow and performance, especially in salty, slushy, or dusty New England conditions around Danvers, MA.

• Rectangular airbox near the passenger-side fender
• Secured with clips or screws for tool-light access
• Feeds the intake tube ahead of the throttle body

The cabin air filter is typically behind or beneath the glove box within the HVAC housing.

Access usually involves opening or lowering the glove box and removing a small access door in the HVAC case. This positioning lets the filter clean incoming air before it reaches the vents, reducing pollen and road dust common across the North Shore. If trim fasteners are tight or brittle, our technicians can handle the job cleanly and quickly.

• Located behind/below glove box in HVAC housing
• Small rectangular access door with tabs or screws
• Protects passengers from pollen, dust, and debris

The engine air filter protects the 5.7L V8’s intake for combustion, while the cabin air filter cleans air entering the HVAC for passengers.

On the 2016 Ram 2500, the engine filter lives in the under-hood intake box, screening dirt that can affect power and fuel economy. The cabin filter sits in the HVAC case near the glove box, trapping pollen and dust so the interior air stays cleaner around Danvers and Greater Boston commutes.

• Engine filter: intake protection for performance and efficiency
• Cabin filter: HVAC air quality for occupants
• Two different locations and service procedures

Engine: reduced power, rough idle, lower mpg; Cabin: weak airflow, persistent haze on glass, or musty odors.

If your 2016 Ram 2500 feels sluggish or the HVAC struggles on Route 114, check both filters. New England’s sanded winter roads and spring pollen can load filters faster. Addressing these symptoms early helps the 5.7L V8 maintain smooth response and keeps cabin air fresh for daily drives across the North Shore.

• Engine symptoms: throttle lag, poorer fuel economy
• Cabin symptoms: reduced vent output, odors, more dust
• Visual check: dark, debris-laden pleats indicate replacement

Engine filters are often DIY-friendly; cabin filters may require glove box/trim removal that’s easier at a dealer.

The 2016 Ram 2500’s engine airbox uses clips or screws, making home replacement feasible. Cabin filter access can be tighter and risks broken tabs if forced. Dealer service adds OEM-spec parts, intake housing checks, and a visual MAF inspection, plus easy online booking via our schedule service tool in Danvers, MA.

• DIY feasible for engine filter with basic tools
• Cabin filter access varies and may involve trim clips
• Dealer adds inspections and correct Mopar-spec fit

Yes—our service team installs Mopar OEM-spec engine and cabin air filters for the 2016 Ram 2500.

Mopar filters match the factory dimensions and media the Ram 2500 was designed around, supporting proper airflow, sealing, and HVAC performance. Using OEM parts also helps maintain consistent fit over time in tough New England conditions. Book online and check service specials before your visit.

• Mopar OEM filters sized for the 5.7L V8 intake and HVAC
• Factory-style sealing to prevent bypass dust
• Backed by dealer installation and documentation

Visit Herb Chambers Chrysler Dodge Jeep RAM FIAT of Danvers at 107 Andover St, Danvers, MA 01923, and schedule an appointment online.

Our factory-certified team services Ram trucks for drivers from Peabody, Beverly, Lynnfield, Andover, and Salem. We install Mopar-spec cabin filters and verify HVAC operation so your 2016 Ram 2500 stays comfortable in every season. Check current service specials before booking.

• Convenient Route 114 location with online scheduling
• Mopar-spec filters sized for proper HVAC airflow
• Service for North Shore and Greater Boston customers

Open the airbox, remove the filter, and replace it if the pleats are dark, clogged, or damaged.

With the hood up, release the airbox clips or screws on the passenger side, lift the cover, and slide the filter out. Hold it to light—if little light passes through or debris is embedded, it’s time to replace. For a quick inspection with OEM guidance, book via our schedule service page.

• Passenger-side airbox with clips/screws
• Check for heavy discoloration and debris in pleats
• Re-seat cover evenly to ensure a proper seal

Install the cabin filter with the airflow arrow pointing in the direction of airflow (toward the blower/inside the HVAC housing).

Most replacement filters include arrows stamped on the frame—match them to the airflow direction indicated on the HVAC cover. Correct orientation ensures the media loads properly and seals against bypass dust, important for Danvers-area pollen and coastal dust. If unsure, our technicians can install and verify fitment.

• Follow arrows marked “AIR FLOW” on the filter
• Seat evenly to prevent gaps and noise
• Reinstall access door fully latched

Herb Chambers Chrysler Dodge Jeep RAM FIAT of Danvers serves North Shore and Greater Boston drivers—including Peabody, Beverly, Lynnfield, Andover, and Salem—with OEM-spec air filter maintenance for the 2016 Ram 2500. Local conditions like winter sanding, coastal salt spray, and heavy spring pollen can load filters faster than expected, affecting both engine response and cabin comfort. Our Mopar-trained team inspects the engine intake filter and the cabin HVAC filter, then installs the correct parts to factory standards. You can check current service specials and schedule service online. Find us at 107 Andover St (Route 114), Danvers, MA 01923; we’re easy to reach for work trucks and daily drivers alike. Clear airflow helps your V8 stay responsive and your cabin stay clean year-round—book your appointment today.

Our air filter service for the 2016 Ram 2500 follows a clear, professional sequence to protect performance and in-cabin air quality. First, we visually inspect the engine intake system, open the airbox, assess filter media condition, and replace the engine air filter when needed with a Mopar-spec part. Next, we access the HVAC housing near the glove box to inspect and, if required, replace the cabin air filter to restore airflow and reduce dust and pollen. We also check the intake housing for cracks or loose clamps and perform a visual MAF/throttle body inspection for debris. Installation includes proper seating, sealing, and disposal of old filters. Ready to book? Use our schedule service tool, and review service specials before you arrive.

The 2016 Ram 2500’s 5.7L V8 uses a rectangular pleated engine air filter in the passenger-side airbox and a rectangular cabin filter within the HVAC housing behind or beneath the glove box. Mopar OEM filters are built to the Ram platform’s dimensions and sealing profiles, helping maintain proper intake airflow and HVAC performance. While exact replacement intervals vary with use and environment, New England’s sanded winter roads and seasonal pollen can increase debris loading—inspect regularly and replace as needed to support power and clean cabin air. Bring your 2016 Ram 2500 to Herb Chambers Chrysler Dodge Jeep RAM FIAT of Danvers in Danvers for OEM-spec filter service — schedule service.