2010 Dodge Challenger Air Filter in Danvers, MA

The 2010 Dodge Challenger engine air filter sits in a sealed airbox within the engine bay, upstream of the intake duct.

This airbox is designed to draw outside air through the filter before it reaches the V6 intake, protecting the mass airflow path from dust and debris common on New England roads. Access typically involves unclipping or unscrewing the airbox lid and lifting out the panel-style filter. Our Danvers service team can inspect and replace it during the same visit.

• Location: engine bay airbox ahead of the intake tract
• Access: release fasteners, lift lid, remove panel element
• Function: filters combustion air to protect engine and sensors

The 2010 Dodge Challenger cabin air filter is typically located behind the glove box in the HVAC intake plenum.

This position lets the filter scrub pollen, dust, and particulates before they enter the passenger vents—a benefit during North Shore pollen spikes and winter road dust. Access usually requires lowering or removing the glove box and sliding the filter tray out. Our technicians can replace it while confirming the blower door and seals are properly seated.

• Location: behind-glove-box HVAC intake area
• Access: lower/remove glove box, extract filter tray
• Benefit: cleaner cabin air and better HVAC performance

The engine air filter protects the V6 intake for combustion, while the cabin air filter cleans air for passengers through the HVAC system.

On a 2010 Dodge Challenger, the engine filter sits in the underhood airbox and keeps dust from reaching the intake and sensors. The cabin filter mounts near the HVAC intake (often behind the glove box) and targets pollen and fine particles you breathe. Both matter, but they serve distinct systems and require different replacement steps.

• Engine filter: underhood airbox; protects engine and MAF path
• Cabin filter: HVAC intake; improves in-cabin air quality
• Different access points, similar panel-style media

Common signs include reduced power, lower fuel economy, and rough idle for the engine filter; weak airflow and musty odor for the cabin filter.

In a 2010 Dodge Challenger, New England dust and road grit can load the engine filter, causing sluggish throttle response. For the cabin filter, spring pollen or winter debris can restrict HVAC airflow and increase fan noise. If you notice these symptoms, a quick inspection can confirm condition and direction-of-airflow orientation on replacement.

• Engine: hesitation, poorer MPG, darker filter media
• Cabin: reduced vent flow, odor, increased blower noise
• Visual check: sunlight test and debris on pleats

Yes, many owners can DIY the engine filter, while the cabin filter often needs glove box removal—dealer service ensures OEM fit and intake checks.

The 2010 Dodge Challenger’s engine filter swap is usually straightforward with basic tools. Cabin filter access is tighter and benefits from careful trim handling to avoid broken clips or mis-seated doors. Our Danvers team also inspects the intake housing, seals, and MAF path to prevent unmetered-air issues.

• DIY-friendly: engine filter panel in airbox
• More involved: cabin filter behind glove box
• Dealer adds: OEM-spec media, housing/MAF inspection, disposal

Yes—our service department installs genuine OEM-spec Mopar filters on Dodge vehicles, including the 2010 Dodge Challenger.

Using Mopar filter media helps maintain proper airflow, sealing, and filtration efficiency for your Challenger’s V6 and HVAC system. OEM-spec parts are selected for correct dimensions and pleat density, supporting performance and longevity on Boston’s varied roads. Ask our advisors to show you the part box and verify the spec during your visit.

• Brand: Mopar OEM-spec for Dodge applications
• Fitment: correct seal, tray, and airflow direction
• Support: installed by factory-trained technicians in Danvers

Follow the OEM interval listed in the 2010 Dodge Challenger owner’s manual, adjusting sooner for dusty or salted-road conditions.

North Shore driving can load filters faster due to spring pollen and winter sand/salt dust, especially if you commute on Route 114 or I‑95. We recommend inspecting at each oil change and replacing once restriction or contamination is evident. Our technicians document condition and can timestamp your next check.

• Reference: owner’s manual maintenance schedule
• Inspect: at each oil change for restriction/debris
• Adjust: sooner for construction zones or unpaved travel

Use the OEM interval in your 2010 Dodge Challenger owner’s manual, and consider earlier replacement after heavy pollen or winter debris.

Pollen from spring blooms in Beverly and Salem and winter particulates can clog the media and reduce HVAC performance. We recommend a visual check during routine service and replacement when pleats are dark or airflow drops. A fresh cabin filter helps defog windows faster and improves in-cabin air quality.

• Reference: owner’s manual interval for cabin filter
• Trigger: reduced airflow, odor, dirty pleats
• Tip: replace before peak allergy seasons for comfort

Drivers throughout the North Shore and Greater Boston—including Peabody, Beverly, Lynnfield, Andover, and Salem—rely on our Danvers location for accurate air filter inspection and replacement on the 2010 Dodge Challenger. Local conditions such as spring pollen, fall leaf debris, and winter sand/salt dust can load both engine and cabin filters faster than average, so periodic checks help preserve performance and HVAC airflow. Our advisors can review your driving patterns and recommend inspection timing that fits New England seasons. To visit, head to 107 Andover St (Route 114), Danvers, MA 01923. Have questions or ready to book? Use our online scheduler to schedule service and review our current service specials before you arrive.

Our air filter service for the 2010 Dodge Challenger is structured for clarity and consistency. We begin with a visual inspection of the engine air filter, airbox lid, and seals, then replace the panel element if restricted. Next, we inspect the cabin air filter behind the glove box, verify the airflow arrow orientation, and replace it as needed. The intake housing and ducts are checked for cracks or loose clamps, and the MAF/air duct path receives a visual cleanliness check. After installation, we reset the service notes on your repair order and dispose of used filters responsibly. See our service specials for savings and schedule service online for a convenient appointment.

The 2010 Dodge Challenger uses an underhood panel-style engine air filter sized for the 3.5L V6 intake path, along with a rectangular cabin air filter mounted at the HVAC intake. OEM-spec Mopar filters are engineered for correct seal compression and pleat density to maintain airflow and filtration efficiency. Always match the part to your year/make/model and verify the airflow marking during install to prevent bypass. For replacement timing, reference the owner’s manual maintenance chart and adjust based on local dust, pollen, and winter road debris exposure. Bring your 2010 Dodge Challenger to Herb Chambers Chrysler Dodge Jeep RAM FIAT of Danvers in Danvers for OEM-spec filter service — schedule service.